Lichtmachine/Stator wiring

Basic info on DKW NZ 350's

Moderator: Mods

Post Reply
Gespenster
Novize
Posts: 2
Joined: Wed Aug 08, 2018 11:52 am

Lichtmachine/Stator wiring

Post by Gespenster » Tue Sep 11, 2018 6:13 pm

Hello Everyone,

I am restoring a DKW NZ 350. And I now have to put the LiMa/Stator on the engine. The wiring on the bike has already been done. However the wiring on the stator got lose at some point. I connected the wires just for now to the connectionpoint that was closest to it. I want to make sure that everything is wired up correctly.

I can not figure out how I can measure which wire is which, as seen on the wiring diagrams. How can I figure out the difference between the 2 wires that go in to connector 1 and the wire that goes in connector 20.
Also I am wondering how I should connect the ground wire.

I hope you guys got some advise or pictures for me.

Thanks!

Image

Image

Image
Frank
SUPPORTER 2016
SUPPORTER 2016
Posts: 400
Joined: Thu Nov 19, 2009 8:23 pm
Location: Finland

Re: Lichtmachine/Stator wiring

Post by Frank » Sat Sep 15, 2018 11:26 pm

Hi,

Check this thread how to measure which wire comes to 1 and which to 20:

viewtopic.php?f=1&t=1454

The earth wire from the coil box connects with a ring connector and a screw to the threaded hole in the dynamo alloy cover which can be seen on your second image (close to terminal 20)


Good luck!



//Frank
Gespenster
Novize
Posts: 2
Joined: Wed Aug 08, 2018 11:52 am

Re: Lichtmachine/Stator wiring

Post by Gespenster » Tue Sep 18, 2018 8:53 pm

Hello Frank,

Thank you for your help! I connected the ground the way you described. I will read through the given topic so I can measure the wires and connect them the right way.

Thanks a lot!

Joe
Post Reply