Powerdynamo for aluminium engine nz350
Posted: Tue Apr 11, 2017 1:20 pm
Hi guys, help needed. I dismantled my 1943 nz350 in 2012 and purchased the parts needed for a rebuild. I have just finished the rebuild and fitted a 'powerdynamo' 12v electronic ignition purchased in 2013, but I cannot get the new flywheel to tighten down on the crankshaft. I have removed the woodruff key as per the instructions. How do you hold the crankshaft at 4mm BTDC and tighten down the flywheel at the same time. The flywheel fits over the stator and is drawn on with the aid of the magnets , but tightening the supplied bolt the flywheel and/ or the crankshaft moves? The flywheel even after striking with a block of wood and hammer will not grip the crankshaft and it just spins?
What am I missing in the fitting issue
Timo Mann
What am I missing in the fitting issue
Timo Mann