Good to hear you fixed the kickstarter!
Have a nice summer!
Search found 414 matches
- Sat Mar 07, 2020 7:40 pm
- Forum: Everything NZ 250
- Topic: NZ 250 bing carb problem?
- Replies: 2
- Views: 495
Hi, The carb in the link is a post war Bing, very similar to the old AJ, but it should work perfectly on a NZ. The pre war Bing was a AJ 2/24 and on those the main jet was 100 and the needle jet 270. Sounds like there is something clogged in the carb, or the fuel level in the floater bowl too low, i...
Hi Chris, Have you checked the 1/4" steel ball (pos. 18 in the image) is not missing between the clutch screw and the clutch rod (on the right side of the engine)? The correct tightening on the pressure springs are: tighten the adjuster nuts so much that 1mm of the studs comes through the nut (1mm o...
Hi Chris, The clutch discs are identical on all alu engine NZ`s (250/350/500), the only difference is the amount of discs. Im not so good on IZH, but in my opinion a IZH 350/49 clutch with (simplex chain) up to some mid 50´s should fit on a NZ350/350-1 engine. The later IZH clutches with duplex chai...
Hi, At the NZ homepage it says: "In June 1940 the rear end of the bike was shortened with 40 mm (from frame number 582559), which lifted the rear seat with 4 mm." I disagree with this and had a discussion with Nikola about this and he told me to put the theme on the forum for discussion. I have meas...