What about the DKW decals for the sides of the tank? Where can you find those at?

Regards
Zack

MY piston does not have the size stamped on it. I looked all over it and couldnt find anything. I guess I will have to measure the existing piston ring that I have.

My gas tank has a nice size dent on top. I would like to "pop" the dent out so you cannot see it anymore. I have tried some methods but have been unsuccessful. Does anyone have any ideas or methods that they have used? Here are some pictures so you can see the tank and the dent. Thank you for your h...

I am still looking for the rear brake drum for my NZ 350 (part no. 122853-0) and the parts that go inside the brake drum as well. If anyone can help me with this I would really appreciate it. Thank you.

Zack

Hello

I need new piston rings for my NZ 350 motor. Greiner has them for sale however the only problem I am having is figuring out what size I need. Does anybody know what size I do need? I looked in the manual and they listed 3 or 4 different sizes. Thank you

Regards
Zack

Sorry to interupt on this thread again but I searched Oldtimer Garage and could not find the plate. Perhaps I am looking in the wrong location? Thanks

Regards
Zack

Are there reproductions of these plates? If so where can you buy them at? I have the top plate with all the info on it but would still need the bottom plate as pictured above. Thanks

Zack

Im looking for new piston rings for my NZ 350. Does anyone make these new? Thanks

Zack

Ok Thanks. I will continue my searches on German Ebay and on this forum for the correct parts that I need. If anyone has any leads please message me and let me know.

Best Regards
Zack

Ok Thanks. I noticed Oldtimers sells the rear brake drums. Are these any good? Where would you get the internals for it so it works? I would also need the lever for the brake rod to connect to. Thanks

Zack

Is this the correct rear brake drum for a NZ 350?

http://www.ebay.de/itm/DKW-NZ-250-ev-35 ... 27c77e1f4e

Thanks

Zack

Hello

Do you have pictures of the original 39-41 early levers?

Zack

The parts I need from the parts list are 124802-1 and then the complete rear axel with all the nuts and washers. I know you can get a reproduction rear axel from Oldtimers but I am looking for a complete original one.

Zack

Where do you get the adjuster from? Does Oldtimers sell them?

My front brake cable appears to be to long. Do you have to cut these to make them fit? I got mine from Oldtimers. Here is a picture of my issue.

Zack