Hi All,

Original DKW has 2 screws. IZH 3 screws

Hi All,

Can any one tell me if the 350-1 petrol tank has a male thread for the petrol tap?
thanks

Hi Rino, I am having the same trouble, my clutch is about the same thickness of cork plates, I am using good transmission oil for motorcycle clutch and gear box. I am going to try tightening the clutch springs some more. I cant find a proper setting for these springs in the workshop manual, somone w...

Hello everyone,
I need a bit of information regarding petrol tanks for 350-1.

When were the bolt holes fitted for the gasmask holder, I have been offered a tank but it does not have the bolt holes, so I'm not sure if its the correct tank.

Hello Centi I have one of these generators installed on my SB500. Its well made and works OK, the drawback is there is no ignition advance, which looses some of the power of the engine. It doesnt run as well as it did with the points. I have converted my original DKW dynamo to fit a Honda alternator...

NZ 350-1 Petrol tank wanted.

Thanks Rob

Hello to everyone,

Does any one know who made DKW dynamos and ignition systems during the war?

Thanks Rob

Another little piece of information you might find interesting, There are 2 sizes of mainshaft 24mm and 25mm, If you have a 25mm mainshaft tou can replace the original mainbearings with NA49 needle roller bearings. These are 2mm too short so an extra spacer needs to be fitted between the bearing out...

Hi All, I have just Checked the gear teeth in my gearbox, and made a list of the number of teeth on each gear. On checking in the parts book 605/12, 41 and 44 the amount of teeth on the gears didnt match, on looking in The instandsetzungsandweisungen Page 87 bild 154 shows the correct amount of teet...

Hi All,
Thomas, do you know the dimensions of the different springs, I have 2 or 3 different springs here, and I dont know which is the correct one for a type 43.
Thanks Rob