I was searching ebay and came across these nameplates. I not real sure if they would be correct for my bike 1939 NZ 350 and if they are which one would be correct? Can anyone help me out on this? Thank you.
Zack
nameplate
Moderator: Mods
Re: nameplate
Hi,
No one of these are correct for your NZ unless you have a Framo passenger seat on your NZ. Are you searching for a "Entstörung" plate, or for a plate for a Framo driver seat?
// Frank
No one of these are correct for your NZ unless you have a Framo passenger seat on your NZ. Are you searching for a "Entstörung" plate, or for a plate for a Framo driver seat?
// Frank
Re: nameplate
Hi Frank
Im not really sure. I have a Pagusa seat cover but thats all I really know.
Also in regards to the frameplate, what size number (in mm) stamps should be used? I need to put in the information on it so I can then attach it to my bike. Thanks for your help.
Best Regards
Zack
Im not really sure. I have a Pagusa seat cover but thats all I really know.
Also in regards to the frameplate, what size number (in mm) stamps should be used? I need to put in the information on it so I can then attach it to my bike. Thanks for your help.
Best Regards
Zack
Re: nameplate
Hi Zack,
A Pagusa rubber seat shall not have any plate at all. I measured the height of the stamped numbers on a original -39 type plate and they should be 3 mm high.
// Frank
A Pagusa rubber seat shall not have any plate at all. I measured the height of the stamped numbers on a original -39 type plate and they should be 3 mm high.
// Frank
-
martdapp
- Master Mechanic
- Posts: 950
- Joined: Sat Jan 19, 2008 9:46 am
- Location: Hoensbroek Niederlande
Re: nameplate
[quote="Frank"]Hi Zack,
Frank's answer is correct, and you have the correct driverseat.
I still have a Pagusa rearseat for your NZ.
Martin
Frank's answer is correct, and you have the correct driverseat.
I still have a Pagusa rearseat for your NZ.
Martin