350-1 Questions

[Freddieab]

Hi All,

I am quite close to assembling two NZ350-1, mine and a friends, and have a lot of questions about which parts to use. One is mid '44 and the other is early '45. I have tried in vain to find the answers on the forum so I apologise if these have been asked before.
I would appreciate any guidance you can offer. I understand that all the parts could and would be used for various reasons, but I would like to be as accurate as possible.

1. Which Side Stand is Correct?

This is a link to the stands I have. http://imageshack.us/g/1/9836065/
They are all different in some way. I know the black one is IZH and I think the beige one is also. The other stand is shorter and has a part number on it. Two stands have grease nipples and one does not. The top ends are different also. Can anyone tell me which is the genuine DKW stand?

2. Which Centre Stand Is Correct?

http://imageshack.us/g/1/9836072/
The black centre stand was on my NZ and has beige paint remaining but Zylinder viewtopic.php?f=18&t=742 has a stand similar to the green one in the photos. Which one is correct for NZ350-1 for 44 and 45?

3. Gear Change Lever.

Which of these levers should be on a -1 for 44 and 45?
http://imageshack.us/photo/my-images/202/imag0547j.jpg/

4. Handlebar Clamp.

Which clamp for a -1 for 44 and 45?
http://imageshack.us/g/1/9836084/

5. Hand Change Lever

Are these both DKW?
http://imageshack.us/g/1/9836098/

6. Mudguard Profile.

Which profile is DKW and which is IZH?
http://imageshack.us/photo/my-images/507/imag0562p.jpg/

7. Rear Foot Pegs.

Which pegs for a -1 for 44 and 45?
http://imageshack.us/g/1/9836110/

8. Cast Iron Cylinder?

My -1 has aluminium covers on the cylinder but is clearly stamped 12 / 44 as are all the engine internals. Is this correct as I understood -1 cylinders to be all cast iron?
http://imageshack.us/photo/my-images/513/imag0551j.jpg/


Thanks in advance for any info.
Freddie