DKW NZ 350

Hi,

Could someone please help me out with the dimensions of the HASAG ignition key (the one for NZ 250, the key part is pretty easy, could be made out of a metal "sheet" with a depth of a few millimetres...)?

I do have the switch, though lack the key...

Regards

stalker wrote:Hi,

Could someone please help me out with the dimensions of the HASAG ignition key (the one for NZ 250, the key part is pretty easy, could be made out of a metal "sheet" with a depth of a few millimetres...)?

I do have the switch, though lack the key...

Regards

Lock here!

http://www.ebay.de/itm/Zundschlussel-HA ... 5af1d5db03

Martze wrote:

stalker wrote:Hi,

Could someone please help me out with the dimensions of the HASAG ignition key (the one for NZ 250, the key part is pretty easy, could be made out of a metal "sheet" with a depth of a few millimetres...)?

I do have the switch, though lack the key...

Regards

Lock here!

http://www.ebay.de/itm/Zundschlussel-HA ... 5af1d5db03

Hi!

Thanks for answering... Though I would rather like to make my own based on some measurements... this one looks a bit... well it is not that beautiful, the guy would be better of making it out of a metal sheet completely

Best Regards

Here is a better replica. I bought it too and find it very good.
http://www.ebay.de/itm/DKW-Nz-350-Zunds ... 3a86cd5446
regards

Martze wrote:Here is a better replica. I bought it too and find it very good.
http://www.ebay.de/itm/DKW-Nz-350-Zunds ... 3a86cd5446
regards

Thank you very much for answering! Could you just measure the notches with a caliper if it is not a problem for you? I have access to laser cutting so it is better for me to manufacture it by myself (the same applies for the upper part of the key too...)

These are the required dimensions presented on a sketch (in case the upper two notches on the key are symmetrically placed on the key), plus the thickness is a required information too:




Best Regards