DKW NZ 350

Not wanting to weld up anything original..

Could someone state me which holes that are original?

Does anyone have the correct thickness for the shaft in the hinge on the mudguard as well- I need to make a new one as you can see



Thanks

Svenn

I really need to know the distance from the edge on the cut-out for the hinge to:

-The two holes for the lamp- distance A and B
-The lower hole for the red cat-eye reflector - distance C


I need excact meassurements, since I ended up welding up all of the holes.

Svenn

I am facing the same problem when restoring the rear fender on my -39 NZ 350, the fender is full of holes, so I should be very grateful if someone could supply some pics how the hinge should look like and also how the rear part of an original fender should look like (holes).

svenn
i'll take some measurements on my 1939 nz250 for you with my calipers.i the next few days.
jeff

I actually bought a new rear part of the rear fender for my bike.
The old one had to many holes and fixes.. and was missing that embossed spot.
But the new one also has, i think, 2 holes to much (someone probably put on some bigger rear light once).

Here a picture to show what i mean with that embossed spot:

I have the same problem with my fender, theres a lot of holes drilled and also the embossed spot is welded and repaired.
Maybe its easier to search for a better one on ebay, of course everthing is possible to repair, but I mean i dont think its worth the job.
Is the embossed spot stamped in one piece together with the fender, or is it a separete part velded/soldered to the fender (the one i have is in so bad shape so its impossible to say how it should look like)?

I measured 4 different mudguards at the weekend for a friend (and took a bunch of photos I will try to upload later) all had different holes , but the top one measures approx 12.5 cm (to centre of hole) from the bottom edge of the hinge (ie measurement A on Svenn's drawing). However, I found the best way to measure it was to turn the guard over and measure the inside. From the very top edge of the guard and measuring with a steel rule (ie straight, not a tape measure placed on the surface) the measurement is 150 mm (approx!). That is for both early and late type mudguards (and an Izh one I had too).

hope these pics come out ok

Thanks a lot for the pics! I shall take a new look att my fender tomorrow and compare it with the pics and the measurements.

svenn wrote: ↑

Sun Jun 17, 2007 10:27 am

Not wanting to weld up anything original..



Thanks

Svenn

Hello
there have been several production of mudguard nz250 ?
this one looks different than Ersatzteil list 58
It s ok for nz 250 ?
Regards