id badge removal

Basic info on DKW NZ 350's

Moderator: Mods

Post Reply
Posts: 11
Joined: Tue Sep 20, 2016 8:58 pm

id badge removal

Post by Asplund » Mon May 01, 2017 9:15 pm

It is usually difficult to remove the ID sign on the frame without breaking it. In my case the sign was in good condition and in addition, it had no manufacturing year so it was unique.
I have tried several methods and what has worked best so far is to knock out the rivets from behind. Which does not work on the NZ frames due to the construction. But I fund out a way to do that even on these frames.

Drill two holes in height with the rivets a bit outside of the id tag. Insert a screwdriver or mandrel into the hole and place it against the end of the hardened rivet to the plate. Hit a little hammer on the chisel or the mandrel and out comes the rivet. When the rivet has begun to creep out pull it out with a pliers or gently push under the head of the rivet whit a knife or chisel. Do not put the tool behind the sign, then it breaks. It's no big job to rebuild the holes when you renovate the frame.

Regards Mikael
Posts: 414
Joined: Thu Nov 19, 2009 8:23 pm
Location: Finland

Re: id badge removal

Post by Frank » Mon May 01, 2017 9:49 pm


On behalf of Mikael, I attach an picture he sent me.

You do not have the required permissions to view the files attached to this post.
Tool Cleaner
Tool Cleaner
Posts: 93
Joined: Fri Feb 15, 2013 11:24 pm
Location: The Netherlands

Re: id badge removal

Post by Motorboy13 » Tue May 02, 2017 7:46 pm

That's good thinking!!!if you want to take of the ID plate!!! =D> =D>

But Personaly i would not take it off the Frame unless it is in realy in bad shape!!

just to show it is 100% Original!! :D


Post Reply