Hello Everyone,
I am restoring a DKW NZ 350. And I now have to put the LiMa/Stator on the engine. The wiring on the bike has already been done. However the wiring on the stator got lose at some point. I connected the wires just for now to the connectionpoint that was closest to it. I want to make sure that everything is wired up correctly.
I can not figure out how I can measure which wire is which, as seen on the wiring diagrams. How can I figure out the difference between the 2 wires that go in to connector 1 and the wire that goes in connector 20.
Also I am wondering how I should connect the ground wire.
I hope you guys got some advise or pictures for me.
Thanks!
Lichtmachine/Stator wiring
Moderator: Mods
-
- Novize
- Posts: 2
- Joined: Wed Aug 08, 2018 11:52 am
Re: Lichtmachine/Stator wiring
Hi,
Check this thread how to measure which wire comes to 1 and which to 20:
viewtopic.php?f=1&t=1454
The earth wire from the coil box connects with a ring connector and a screw to the threaded hole in the dynamo alloy cover which can be seen on your second image (close to terminal 20)
Good luck!
//Frank
Check this thread how to measure which wire comes to 1 and which to 20:
viewtopic.php?f=1&t=1454
The earth wire from the coil box connects with a ring connector and a screw to the threaded hole in the dynamo alloy cover which can be seen on your second image (close to terminal 20)
Good luck!
//Frank
-
- Novize
- Posts: 2
- Joined: Wed Aug 08, 2018 11:52 am
Re: Lichtmachine/Stator wiring
Hello Frank,
Thank you for your help! I connected the ground the way you described. I will read through the given topic so I can measure the wires and connect them the right way.
Thanks a lot!
Joe
Thank you for your help! I connected the ground the way you described. I will read through the given topic so I can measure the wires and connect them the right way.
Thanks a lot!
Joe