Lichtmachine/Stator wiring
Posted: Tue Sep 11, 2018 6:13 pm
Hello Everyone,
I am restoring a DKW NZ 350. And I now have to put the LiMa/Stator on the engine. The wiring on the bike has already been done. However the wiring on the stator got lose at some point. I connected the wires just for now to the connectionpoint that was closest to it. I want to make sure that everything is wired up correctly.
I can not figure out how I can measure which wire is which, as seen on the wiring diagrams. How can I figure out the difference between the 2 wires that go in to connector 1 and the wire that goes in connector 20.
Also I am wondering how I should connect the ground wire.
I hope you guys got some advise or pictures for me.
Thanks!
I am restoring a DKW NZ 350. And I now have to put the LiMa/Stator on the engine. The wiring on the bike has already been done. However the wiring on the stator got lose at some point. I connected the wires just for now to the connectionpoint that was closest to it. I want to make sure that everything is wired up correctly.
I can not figure out how I can measure which wire is which, as seen on the wiring diagrams. How can I figure out the difference between the 2 wires that go in to connector 1 and the wire that goes in connector 20.
Also I am wondering how I should connect the ground wire.
I hope you guys got some advise or pictures for me.
Thanks!