On my nz350 I have an Amal 24c2a carburetor but I am having some problem.
The engine starts fine but then does not rev up and does not run smoothly.
The air filter and carburetor are perfectly clean, the main jet is 130, the needle is in 3rd position.
What is wrong?
carburetion problems
Moderator: Mods
- thunderbolt
- Tool Cleaner
- Posts: 42
- Joined: Fri Aug 14, 2015 2:49 pm
Re: carburetion problems
are you sure it's the correct carburettor? My 1939 NZ350 has an Amal-Fischer M76-426 fitted.
Re: carburetion problems
I know is not the original carburetor but it was working fine until two weeks ago.
I havent modified anything but suddenly it has the described problems.
I havent modified anything but suddenly it has the described problems.
-
- Tool Cleaner
- Posts: 92
- Joined: Fri Feb 15, 2013 11:24 pm
- Location: The Netherlands
Re: carburetion problems
any luck jet on the Carb./engine running problems????
it seems like a fuel flow or ignition problem !!
make sure the fuel system/carb. is clean and your feultap is in good order (smal test will do)
ignition points check them as wel if the gap is to smal /corrosion on the points ed.
good luck!!
greatings
it seems like a fuel flow or ignition problem !!
make sure the fuel system/carb. is clean and your feultap is in good order (smal test will do)
ignition points check them as wel if the gap is to smal /corrosion on the points ed.
good luck!!
greatings