New piston for NZ 350-1

Basic info on DKW NZ 350's

Moderator: Mods

Post Reply
Arnost
Novize
Posts: 5
Joined: Wed Nov 05, 2008 10:58 am
Location: Czech Rebublic

New piston for NZ 350-1

Post by Arnost » Thu Feb 26, 2009 4:19 pm

Hello,
I am going to do cilinder grinding on my byke. Do you have any expiriences with the pistons play. Accorging to the Werkstatthandbuch it should be 0.17mm. But it was for the pistons wich were "cut into". I hope to use Russian Ish piston. Or is there any other source of good pistons for NZ 350-1?
Best Wishes
Arnost from Prague
Top
Post Reply

Return to “NZ Talk”