Dynamo brushes

Here you can post your want adds for NZ 350, 350-1 parts

Moderator: Mods

Post Reply
User avatar
thunderbolt
Tool Cleaner
Tool Cleaner
Posts: 52
Joined: Fri Aug 14, 2015 2:49 pm
Location: England

Dynamo brushes

Post by thunderbolt » Sun May 01, 2016 8:53 am

Hi all,

I need new brushes and springs for my 1939 350NZ. I think the German name is Kohlebürste and the part numbers are:

012115-0 Minus kohle

012894-0 plus kohle

Recommendations where to buy please,

thanks,

Chris
Frank
SUPPORTER 2016
SUPPORTER 2016
Posts: 422
Joined: Thu Nov 19, 2009 8:23 pm
Location: Finland

Re: Dynamo brushes

Post by Frank » Sun May 01, 2016 10:06 am

Hi Chris,

You will find them on German ebay. I have buyed them from this guy:

http://www.ebay.de/itm/Kohlen-brushes-D ... EYxOxKJGYg

Otherwise they are ok, but the wire to the - brush is too long, so you have to cut it and fit a new ring clamp to it.

//Frank
User avatar
thunderbolt
Tool Cleaner
Tool Cleaner
Posts: 52
Joined: Fri Aug 14, 2015 2:49 pm
Location: England

Re: Dynamo brushes

Post by thunderbolt » Mon May 02, 2016 5:32 pm

Thanks again Frank!

I've had the armature cleaned and tested but still no charge, so I will now fit new brushes.

all best,

Chris
Frank
SUPPORTER 2016
SUPPORTER 2016
Posts: 422
Joined: Thu Nov 19, 2009 8:23 pm
Location: Finland

Re: Dynamo brushes

Post by Frank » Mon May 02, 2016 6:38 pm

Hi Chris,

Check also you have all the insulation washers and bushings in place under the two screws holding the brass + brush holder to the stator.
There shall be no contact between the + brush holder and ground.

//Frank
Post Reply